Transom Edge Moulding

[thedink9]

Anyone know where I can purchase the Aluminum edge moulding that is the thickness of the transom and has a small 1/4" edge on it that sits onto of the transom.? I have an older Taco Aftermarket catalog, but it is not in there.
Thanks
Rich (The Dink)

[Capt Chuck]

Good Luck finding it [img]/images/graemlins/frown.gif[/img]

I searched High and Low a few years back without success. I even went to a custom metal fabricator and he couldn't do it. I think originally it took a special jig to make the bend along with the overlapping. I ended up painting mine after filling in the pits with Epoxo 88 , a 2 part aluminum filler which dries rock solid in 6 minutes.
I guess you could do the same and have it powder coated [img]/images/graemlins/wink.gif[/img]

[ScottM]

I searched High and Low a few years back without success.

Did you check with Metan? [img]/images/graemlins/wink.gif[/img] [img]/images/graemlins/laugh.gif[/img]

[thedink9]

Scott

What is Metan?

[Rich]

I think Scott is referring to Metan Marine. The guy has redone a few SeaCrafts. He might have the part laying around, or might know where to get one.

http://www.metanmarine.com

[ScottM]

I think Scott is referring to Metan Marine.

That is correct.

[thedink9]

Rich & Scott

I'll give Metan a call.

Rich

[ScottM]

Rich,
Metan has two SCs in the yard right now, a 23 Sceptre and a 23 CC. Both are going to be total resto projects, so Mike may have the trim you're looking for. He's a tough guy to get in touch with though.

[Rufridr069]

Let me know if he has any. I need some for my 84' 23' CC.

Thanks.