|
|
|
|
#1
06-04-2005, 05:01 PM
|
|||
|
|||
Repar/modification
I am currently putting a new transom in my 73" 20'. Does anyone know what the minimum cutout width can be to accomodate a 200hp optimax. I am tring to cut out as little as possible to accomodate twin livewells.
|
|
#2
06-04-2005, 09:04 PM
|
|||
|
|||
|
Re: Repar/modification
I think your best bet is to measure the turning radius of your engine and add 3-4 inches to each side. You will need to get your steering hooked up to the engine and mount the engine to a saw horse and just measure it to be safe.
strick
__________________
"I always wanted to piss in the Rhine" (General George Patton upon entering Germany)
|
|
#3
06-05-2005, 10:47 AM
|
|||
|
|||
|
Re: Repar/modification
In most Factory manual's, they have all of that imfo.
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Hybrid Mode
