|
|
|
|
#1
09-25-2010, 06:10 PM
|
|||
|
|||
bilge/engine bay prep
just removed my fuel tanks and engine from my inboard savage 23. I want to paint the engine bay area and the area where the fuel tanks reside. Do I need to scuff or sand these areas
before painting? or just degrease and repaint? 
|
|
#2
09-26-2010, 01:00 PM
|
|||
|
|||
|
Re: bilge/engine bay prep
I did mine 2 years ago and all I did was use a scrub brush and strong detergent. My bilge was already scuffed enough.
It would depend on what the surface looks like.
|
|
#4
09-26-2010, 07:39 PM
|
|||
|
|||
|
Re: bilge/engine bay prep
obviously cleaning is important, but I also scuff up everything before paint just to give it the extra bite. Look at it this way. It cant hurt to scuff it up. Just take a few minutes with a DA and some 80 grit. It just may be the difference between a job that last 2 years and one that lasts 10. Might not, but it cant hurt. Be sure to degrease before AND after scuffing.
__________________
1971 Potter built center console.
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Hybrid Mode
