Classic SeaCraft Community  

Go Back   Classic SeaCraft Community > Recovered Threads
FAQ Community Calendar Today's Posts Search

Notices

Reply
 
Thread Tools Search this Thread Display Modes
  #1  
Old 11-08-2015, 08:35 AM
Islandtrader Islandtrader is offline
Senior Member
 
Join Date: May 2007
Location: Tarpon Capital Of The World
Posts: 2,122
Question Stern Drive Not Behaving !

This year I was on an extended trip and the boat has been sitting on a trailer since April (it was cleaned and rinsed well b4 its long nap). The lower unit was stored in a down position (maybe 5-8 on smart gauge). Batteries fully charged. The unit goes up all the way no problem. Lowering it sticks at 10-7. If I jump on it and some works the switch it will go down all the way. Then you can bring it up and down and no sticking.

....leave is sit for a couple of hours and same problem same solution.

Before I put it in the water for the winter season here (Florida) I would like to fix this...any solutions, b4 I replace anything. Oh yes fluids are full and connections are good.

Bravo 1
__________________
[SIGPIC][/SIGPIC]

"If You Done It...It Ain't Braggin"



my rebuild thread: http://www.classicseacraft.com/commu...ad.php?t=18594
Reply With Quote
  #2  
Old 11-08-2015, 09:26 AM
FLexpat FLexpat is offline
Recovered
 
Join Date: Jan 2014
Posts: 669
Default

You might want to try some Kroil on your hinge pins. If I recall correctly (maybe a stretch), either the pump uses high pressure to raise the drive but lower pressure to lower it or it has different surface areas for the pressure in the rams. Either way that would explain no prob coming up but difficult going down.

One diagnostic if you can get at is to remove the aft trim pin from the rams and see if you can lift the drive.

Merc Manual #28 has a short section on it but it does not seem to exactly fit your symptoms.
Reply With Quote
  #3  
Old 11-08-2015, 08:50 PM
jnamowitz jnamowitz is offline
Recovered
 
Join Date: Sep 2015
Posts: 139
Default

I had a similar problem. I took the anodes off the trim cylinders, cleaned up the corrosion under the anodes and haven't had a problem since.
Good luck
Reply With Quote
  #4  
Old 11-09-2015, 07:29 AM
pelican pelican is offline
Senior Member
 
Join Date: Apr 2010
Location: cape may nj
Posts: 596
Default

Quote:
Originally Posted by Islandtrader View Post
This year I was on an extended trip and the boat has been sitting on a trailer since April (it was cleaned and rinsed well b4 its long nap). The lower unit was stored in a down position (maybe 5-8 on smart gauge). Batteries fully charged. The unit goes up all the way no problem. Lowering it sticks at 10-7. If I jump on it and some works the switch it will go down all the way. Then you can bring it up and down and no sticking.

....leave is sit for a couple of hours and same problem same solution.

Before I put it in the water for the winter season here (Florida) I would like to fix this...any solutions, b4 I replace anything. Oh yes fluids are full and connections are good.

Bravo 1


seals are "dry" - common on stern drives that are either trailered,or rack stored.

corrosion block spray - lear research corrosion block spray :http://www.learchem.com/products/corrosion-block.html

use that or CRC656 - forget other products

raise the drive,squirt the pistons and lower the drive - operate it a few times to spread
__________________
do not let common sense get in your way
Reply With Quote
  #5  
Old 11-09-2015, 09:11 AM
Islandtrader Islandtrader is offline
Senior Member
 
Join Date: May 2007
Location: Tarpon Capital Of The World
Posts: 2,122
Default

Quote:
Originally Posted by pelican View Post
seals are "dry" - common on stern drives that are either trailered,or rack stored.

corrosion block spray - lear research corrosion block spray :http://www.learchem.com/products/corrosion-block.html

use that or CRC656 - forget other products

raise the drive,squirt the pistons and lower the drive - operate it a few times to spread
That's funny forget the other products ...I think I own every make of corrosion or lubricant spray on the market! I will dig this one out at let it rip!

Thanks for the other tips also...I'll start with the easiest and work my way back
__________________
[SIGPIC][/SIGPIC]

"If You Done It...It Ain't Braggin"



my rebuild thread: http://www.classicseacraft.com/commu...ad.php?t=18594
Reply With Quote
  #6  
Old 11-09-2015, 06:36 PM
pelican pelican is offline
Senior Member
 
Join Date: Apr 2010
Location: cape may nj
Posts: 596
Default

Quote:
Originally Posted by Islandtrader View Post
That's funny forget the other products ...I think I own every make of corrosion or lubricant spray on the market! I will dig this one out at let it rip!

Thanks for the other tips also...I'll start with the easiest and work my way back


all good


again,common thing on trailered and rack stored boats

seals just get dry - it's a wiper on the cylinder first - the circlip holds it in place,"o" is down lower

salt wicks moisture - pries the wiper and the o ring tight against the piston

do what I stated - it'll be fine

2 products i'm aware of,to neutralize salt and corrosion :
CRC656 and lear research corrosion block - forget anything else ! wd40 is useless...
__________________
do not let common sense get in your way
Reply With Quote
  #7  
Old 11-09-2015, 02:20 PM
kmoose kmoose is offline
Senior Member
 
Join Date: Jul 2006
Location: Ocala, Florida
Posts: 1,817
Default

I've heard that 20 nautical on the water a month keeps things moving like they should.
__________________
[b]The Moose is Loose !
Reply With Quote
  #8  
Old 11-17-2015, 06:25 PM
Terry England Terry England is offline
Senior Member
 
Join Date: Mar 2013
Location: Indian Rocks Beach, Florida
Posts: 895
Default

Quote:
Originally Posted by Islandtrader View Post
......The unit goes up all the way no problem. Lowering it sticks at 10-7. If I jump on it and someone works the switch it will go down all the way......
T-Bucket, was Senior Pelicano correct? Did the lubricant solve your 4 hour erection problem? OUCH - It hurts just reading about it!!!
Reply With Quote
  #9  
Old 11-17-2015, 09:56 PM
Islandtrader Islandtrader is offline
Senior Member
 
Join Date: May 2007
Location: Tarpon Capital Of The World
Posts: 2,122
Default

Quote:
Originally Posted by Terry England View Post
T-Bucket, was Senior Pelicano correct? Did the lubricant solve your 4 hour erection problem? OUCH - It hurts just reading about it!!!
as we speak it goes up,and comes down...I will be gone for two weeks and we will see what happens . I do believe it will be ok. If not we will post again.
__________________
[SIGPIC][/SIGPIC]

"If You Done It...It Ain't Braggin"



my rebuild thread: http://www.classicseacraft.com/commu...ad.php?t=18594
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 10:28 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
All original content © 2003-2013 ClassicSeacraft