wtb engine cover for 1973 23 sceptre

[sisu22]

Mine is just a little to short about 3" It's for a 350 mercruser

[wattaway2]

Don't know what the measurementsure looking for are but I have a engine cover off a 73 cc if needed

[sisu22]

I would be interested what is the depth front to back, mine is 38.50'' measured at the deck,need 40'' thanks

[Vezo, Part II]

Is this for a SeaCraft 23? I have a decent shaped dog box from a 76 20. Measures 37" at floor but does not appear difficult to add 3" ...

Vezo, Part II

[FLexpat]

My stock box fits a 350 just fine and it is ~38" from the aft bulkhead and probably 48-50" from the stern (depending on where you measure). There is enough room to have batteries in front of the motor too and I even have a crankshaft mounted waterpump for a Bravo. I understand if someone shrunk the box a whole lot it would be a problem, but nothing else would fit there except a V6 (not a bad option w gen 5 motors), so it seems odd that your box wont fit w a 350. Maybe remeasure and take a closer look? Just a thought.

[sisu22]

I just bought this boat and engine box is short by 1.50" ,seems previous owner used a shorter one on his rebuild,.Will post picture tomorrow .Thanks for the replies

[FAS]

I have one from a 74 center,I will measure today.from the bottom on the inside?

[wattaway2]

Originally Posted by sisu22

I would be interested what is the depth front to back, mine is 38.50'' measured at the deck,need 40'' thanks

Try and take a look this weekend