Classic SeaCraft Community  

Go Back   Classic SeaCraft Community > Recovered Threads
FAQ Community Calendar Today's Posts Search

Notices

Reply
 
Thread Tools Search this Thread Display Modes
  #1  
Old 06-05-2016, 08:50 PM
Finnatic Finnatic is offline
Junior Member
 
Join Date: Apr 2013
Location: Branford Ct.
Posts: 18
Default A few questions

Hello all it's been a while that I've posted anything and have a few questions. I have a project boat to do with my son. It's a 1972 206 CC. I've had the boat for 3 years now and have it completely striped down ready for the nasty work. I'm freeing up some time these days and want to remove the entire deck and transom. I want to raise the deck to make it self bail also want to raise the transom to accommodate the newer 25" shaft motors. Is 4 inches enough to raise the deck to install scuppers ? Also is 5 inches the amount needed to raise the transom, it's my understanding they ran motors with a 20 inch shaft back in the day. Thanks in advance.
Reply With Quote
  #2  
Old 06-05-2016, 08:53 PM
NoBones NoBones is offline
Pooh Bah
 
Join Date: Apr 2004
Location: Area 442 Somewhere in Florida
Posts: 3,699
Default

72 should be 19' 6"

Raise deck 2 inches
Raise transom 5 inches

Case closed !

Good luck, have fun...
__________________
See ya, Ken ©
Reply With Quote
  #3  
Old 06-05-2016, 09:00 PM
Finnatic Finnatic is offline
Junior Member
 
Join Date: Apr 2013
Location: Branford Ct.
Posts: 18
Default

Quote:
Originally Posted by NoBones View Post
72 should be 19' 6"

Raise deck 2 inches
Raise transom 5 inches

Case closed !

Good luck, have fun...
Thanks NoBones, I didn't thing 2" would be enough, I'm sure you guys know. Not sure about 19'6" the registration states 20'6" as did the last owner.
Reply With Quote
  #4  
Old 06-05-2016, 09:12 PM
gofastsandman gofastsandman is offline
Senior Member
 
Join Date: Mar 2007
Location: W.P.B. ,Fl.
Posts: 4,586
Default

Quote:
Originally Posted by NoBones View Post
72 should be 19' 6"

Raise deck 2 inches
Raise transom 5 inches

Case closed !

Good luck, have fun...
Lightstream
Reply With Quote
  #5  
Old 06-05-2016, 10:02 PM
Terry England Terry England is offline
Senior Member
 
Join Date: Mar 2013
Location: Indian Rocks Beach, Florida
Posts: 895
Default Questionnaire -

Quote:
Originally Posted by Finnatic View Post
Thanks NoBones, I didn't thing 2" would be enough, I'm sure you guys know. Not sure about 19'6" the registration states 20'6" as did the last owner.
2" will probably be fine if you are powering with 140 HP or less 4 S or 150 HP or less 2 S. The 20' boats were designed for 75-115 HP 2 S's - they do fine with a 115. What motor are you planning to hang on it and what do you use the boat for? What is your typical load and your typical daily run?

We need to develop a check off list like -
I. Boat length (please check one) -
1) 15' Scampi
2) 19' Bowrider
3) 20' CC
4) 20' Seafari
5) 23 CC
6) 23 Sceptre/Tsunami
7) 25 SeaFari
8) 27 Seamaster
9) 27 Raceboat
II. Power (please check one)
1) 75- 90 hp 2S / 4S
2) 100-115 hp 2S / 4S
3) 130-150 hp 2S / 4S
4) 150-225 hp 2S
5) 150 - 200 hp 4S
6) 225 - 300 hp 2S
7) 225 - 300 hp 4S
8) Twins - please specify________
9) 240 Bridgeport
10) Rolls-Merlin Go-Devil
11) Quad Bearcats
III. Typical Load / Windage -
1) Tee Top
2) Tee top with electronics box
3) Hardtop
4) Tower
5) Bikini tops - yes / no
6) Fishing gear
7) Dive gear
8) Beer (rounded off to the nearest case)
9) Persons(*) on board
(*) including mother-in-laws
IV. Boat use -
1) Fishing
2) Diving
3) Cocktail cruiser
4) Camping / Cruising
5) Racing
6) Sandbar Party Classic Chick Magnet
7) Tax write off through shell company (i.e. "Trolling Gear Research,
Assessment and Analysis LLC.")

The answer to these questions will help us here at Classic Seacraft provide the best suggestions and route for your well planned endeavors to resurrect the this Classic.
Reply With Quote
  #6  
Old 06-06-2016, 12:32 AM
NoBones NoBones is offline
Pooh Bah
 
Join Date: Apr 2004
Location: Area 442 Somewhere in Florida
Posts: 3,699
Default

Quote:
Originally Posted by Terry England View Post
2" will probably be fine if you are powering with 140 HP or less 4 S or 150 HP or less 2 S. The 20' boats were designed for 75-115 HP 2 S's - they do fine with a 115. What motor are you planning to hang on it and what do you use the boat for? What is your typical load and your typical daily run?

We need to develop a check off list like -
I. Boat length (please check one) -
1) 15' Scampi
2) 19' Bowrider
3) 20' CC
4) 20' Seafari
5) 23 CC
6) 23 Sceptre/Tsunami
7) 25 SeaFari
8) 27 Seamaster
9) 27 Raceboat
II. Power (please check one)
1) 75- 90 hp 2S / 4S
2) 100-115 hp 2S / 4S
3) 130-150 hp 2S / 4S
4) 150-225 hp 2S
5) 150 - 200 hp 4S
6) 225 - 300 hp 2S
7) 225 - 300 hp 4S
8) Twins - please specify________
9) 240 Bridgeport
10) Rolls-Merlin Go-Devil
11) Quad Bearcats
III. Typical Load / Windage -
1) Tee Top
2) Tee top with electronics box
3) Hardtop
4) Tower
5) Bikini tops - yes / no
6) Fishing gear
7) Dive gear
8) Beer (rounded off to the nearest case)
9) Persons(*) on board
(*) including mother-in-laws
IV. Boat use -
1) Fishing
2) Diving
3) Cocktail cruiser
4) Camping / Cruising
5) Racing
6) Sandbar Party Classic Chick Magnet
7) Tax write off through shell company (i.e. "Trolling Gear Research,
Assessment and Analysis LLC.")

The answer to these questions will help us here at Classic Seacraft provide the best suggestions and route for your well planned endeavors to resurrect the this Classic.
Jiminy Christmas Marshtackie......

Did you start early today with the buy one get one..

AKA: BOGO

I know Walgreens was running a special, but jeesh...

You made me half looped just tryin' to read your response..
__________________
See ya, Ken ©
Reply With Quote
  #7  
Old 06-06-2016, 05:44 PM
Terry England Terry England is offline
Senior Member
 
Join Date: Mar 2013
Location: Indian Rocks Beach, Florida
Posts: 895
Default Complete Data, Please

Quote:
Originally Posted by NoBones View Post
Jiminy Christmas Marshtackie......
"Just the facts Ma'am",
Signed, Joe Friday
Reply With Quote
  #8  
Old 06-06-2016, 09:52 PM
CHANCE1234 CHANCE1234 is offline
Senior Member
 
Join Date: Mar 2003
Location: Cape Cod
Posts: 903
Default

Do yourself a favor and raise the transom to 27 inches. 25" shaft will still fit. Wish I made mine that height. If for some reason when you hang the motor you find its two high just trim it down. My suzuki140 is as high as I can get it and it could probably go up another hole if I had the room to do it.
Reply With Quote
  #9  
Old 06-07-2016, 12:30 PM
Islandtrader Islandtrader is offline
Senior Member
 
Join Date: May 2007
Location: Tarpon Capital Of The World
Posts: 2,122
Default

Quote:
Originally Posted by Terry England View Post

We need to develop a check off list like -
I. Boat length (please check one) -
1) 15' Scampi
2) 19' Bowrider
3) 20' CC
4) 20' Seafari
5) 23 CC
6) 23 Sceptre/Tsunami
7) 25 SeaFari
8) 27 Seamaster
9) 27 Raceboat
.
Do you have something against the "Original" 21'
__________________
[SIGPIC][/SIGPIC]

"If You Done It...It Ain't Braggin"



my rebuild thread: http://www.classicseacraft.com/commu...ad.php?t=18594
Reply With Quote
  #10  
Old 06-07-2016, 02:24 PM
Terry England Terry England is offline
Senior Member
 
Join Date: Mar 2013
Location: Indian Rocks Beach, Florida
Posts: 895
Default

Quote:
Originally Posted by Islandtrader View Post
Do you have something against the "Original" 21'
T-3 is very old and forgetful. I started taking Prevagen, you know the stuff made with jellyfish - Now all it think about is Plankton!!
My apologies T-1
Finnatic says he has a 20"-6', maybe it's really one of the of the last 21's. (Well, other than that one we know is in the basement of the CIA)
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 09:40 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
All original content © 2003-2013 ClassicSeacraft