Classic SeaCraft Community  

Go Back   Classic SeaCraft Community > Recovered Threads
FAQ Community Calendar Today's Posts Search

Notices

Reply
 
Thread Tools Search this Thread Display Modes
  #21  
Old 04-01-2019, 10:50 AM
Vezo, Part II Vezo, Part II is offline
Senior Member
 
Join Date: Mar 2012
Posts: 1,026
Default

Tom, does your MA have the 70 gallon option? Didn’t you have an 18 originally, or is this your first SeaCraft?

Michael.
Reply With Quote
  #22  
Old 04-01-2019, 11:38 AM
TomParis TomParis is offline
Recovered
 
Join Date: Dec 2015
Posts: 450
Default

I have only had this boat, and the tank is undersized, the owner I bought it from 3.5 years ago told me he had it replaced and that he chose not to go with a big tank. I suspect the tank is under 30 gallons size. When I pull it I will take some more photos. I am going to reach out to RDS and see how much it will cost to just get another one same size as this one. As I dont go offshore, literally stay with a mile or two of shore. If its too expensive, I may just Redneck it for now and run a 10 gallon above deck tank. Either way I will remove the fuel and pull the old tank myself.
Reply With Quote
  #23  
Old 04-01-2019, 12:10 PM
Vezo, Part II Vezo, Part II is offline
Senior Member
 
Join Date: Mar 2012
Posts: 1,026
Default

I’m curious if RDS comes back close to $10/gallon. Remember you will have to choose between 0.90, or upgrade to 1.25 thickness aluminum. And then coal tar epoxy.

Vezo
Reply With Quote
  #24  
Old 04-01-2019, 12:55 PM
FLexpat FLexpat is offline
Recovered
 
Join Date: Jan 2014
Posts: 669
Default

Some thoughts to consider as you address the fuel leak:
That is a pretty good pile of unsecured wires sitting/bouncing on a grounded aluminum tank.
At least one appears to be a large bat (+) cable; likely capable of carrying >>100A in a surge. Maybe 1/16" insulation?
Most small boats do not have a large circuit breaker/fuse on the bat cables.
Others wires appear to have open ends – not sure what they are.
Ever see what happens to metal when a hot jumper cable hits a grounded piece of aluminum?
Be safe.
Reply With Quote
  #25  
Old 04-01-2019, 01:01 PM
Capt Terry Capt Terry is offline
Recovered
 
Join Date: Jan 2015
Posts: 573
Default Smaller vs Larger Fuel Tank

About 15 years ago I replaced the 47 gallon tank in my Seafari with an RDS tank of the same dimensions. Seemed like a good idea at the time. Now with only lake use and with an ETEC which is not as thirsty as my Merc V6 150, almost wish I had gone with a smaller tank and gained storage area, as I never have the fuel hatch screwed done anyway. Just a thought.
Reply With Quote
  #26  
Old 04-01-2019, 04:31 PM
Basketcase Basketcase is offline
Senior Member
 
Join Date: Aug 2010
Location: Southern NH
Posts: 198
Default

On my 20 Sceptre, the tank would leak if I filled it to the top. It was leaking at the seal between the sender and the tank. How much fuel is in the tank? Before getting too crazy, I'd be tempted to drain it just below any of the outlets and let it sit again to see if it might be leaking from a hose or sender. If the tank is that new, I'd say those are more likely to be leaking than the tank itself.
__________________
1971 Potter built center console.
Reply With Quote
  #27  
Old 04-01-2019, 08:09 PM
gofastsandman gofastsandman is offline
Senior Member
 
Join Date: Mar 2007
Location: W.P.B. ,Fl.
Posts: 4,586
Default

Quote:
Originally Posted by FLexpat View Post
Some thoughts to consider as you address the fuel leak:
That is a pretty good pile of unsecured wires sitting/bouncing on a grounded aluminum tank.
At least one appears to be a large bat (+) cable; likely capable of carrying >>100A in a surge. Maybe 1/16" insulation?
Most small boats do not have a large circuit breaker/fuse on the bat cables.
Others wires appear to have open ends – not sure what they are.
Ever see what happens to metal when a hot jumper cable hits a grounded piece of aluminum?
Be safe.
Sage advice.

You have an original failed tank.
RDS is thick wall.
CG plate still on the tank?
Reply With Quote
  #28  
Old 04-02-2019, 10:09 PM
TomParis TomParis is offline
Recovered
 
Join Date: Dec 2015
Posts: 450
Default

I think I will have to run off a tank sitting on the deck for awhile. So the question for you guys is, how much runtime would a 6 gallon tank last? Obviously its a guesstimate.

20 Seacraft MA with a 1999 Evinrude 115

Thanks for your input!
Reply With Quote
  #29  
Old 04-02-2019, 10:53 PM
FLexpat FLexpat is offline
Recovered
 
Join Date: Jan 2014
Posts: 669
Default

get 2 and dont get overly throttle happy
This will give you a rough idea of consumption rates at various RPMs if properly propped:
http://www.boat-fuel-economy.com/evi...ion-us-gallons
Reply With Quote
  #30  
Old 04-03-2019, 09:09 PM
motowrecker121 motowrecker121 is offline
Recovered
 
Join Date: Mar 2019
Posts: 4
Default

how come nobody is running plastic tanks under the deck?
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 07:49 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
All original content © 2003-2013 ClassicSeacraft