|
|
#1
10-23-2009, 08:04 AM
|
|||
|
|||
Wet transom
The transom on my '72 Seafari was replaced by the previous owner in the mid 80's. In looking to find a leak, I pulled the motor mounting bolts and discovered my transom is wet inside - all four bolt holes. SO I drilled 3 more 1/8" pilot holes, and discovered it is wet from side to side at 6" above the hull bottom. Yet standing on the cavitation plate of my 375 lb motor and bouncing shows no flex in the transom.
Guys, I'm out of my league when it comes to fiberglass. How soon does this need to be addressed?
__________________
Common Sense is learning from your mistakes. Wisdom is learning from the other guy's mistakes. Fr. Frank says: Jesus liked fishing, too. He even walked on water to get to the boat! Currently without a SeaCraft  (2) Pompano 12' fishing kayaks '73 Cobia 18' prototype "Casting Skiff", 70hp Mercury 
|
|
|
Threaded Mode