Classic SeaCraft Community  

Go Back   Classic SeaCraft Community > General Discussion > Repairs/Mods.
FAQ Community Calendar Today's Posts Search

Notices

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #13  
Old 07-01-2010, 11:37 AM
strick strick is offline
Senior Member
 
Join Date: Aug 2003
Location: California
Posts: 2,738
Default Re: odd crack in a 25 Seafari

These pictures are from the port side which is the opposite side of were Connors crack is. I would have had to cut out the bottom of the starboard storage compartment to get any pictures showing the complete stringer and hull were his crack is located. I'm assuming that the hull is configured the same on both sides.

Looking down from the cabin door. The stringer appears to run directly over the step/chine that is cracked.



The crack is about 24 inches up from the bottom of the keel which puts it somewhere close to where you can see the end of the tape measure.



In the picture above note were the stringer ends. The chine/step extends about 16 inches beyond the end of the stringer however the crack is definitely inside or close to the side the stringer were the end of the tape is located.

A couple more shots looking aft







strick
__________________
"I always wanted to piss in the Rhine" (General George Patton upon entering Germany)
Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 05:03 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
All original content © 2003-2013 ClassicSeacraft