Classic SeaCraft Community  

Go Back   Classic SeaCraft Community > Recovered Threads
FAQ Community Calendar Today's Posts Search

Notices

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #1  
Old 06-13-2016, 02:03 PM
abl1111 abl1111 is offline
Senior Member
 
Join Date: Feb 2003
Location: long island, ny
Posts: 1,053
Default Floor Delamination - small area

My 1975 23' Tsunami has (2) small areas just off of each side of the the i/o engine cover hinges and forward 8" or so that is delaminated. Each area is roughly 12"x12". It's obvious that the i/o hinge screws let water in - how much and what damage to the wood floor is unknown.

It's not worth doing an entire floor for.

Whats the best method to inject epoxy into the area and be sure that the entire delaminated area gets epoxy to it ?

Lastly, assuming I want to dry this area out 1st - what dpi you recommend ( short of pulling skin off ) ? Has anyone used the vacuum / evaporation idea ?

This might be a project I do in the winter, under wraps to assure that it gets done correctly.
Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 10:00 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
All original content © 2003-2013 ClassicSeacraft