Quote:
Originally Posted by Old'sCool
I'm in the process of wiring my 20' project and got the Dymo 4200. FWIW, Dymos idea of shrink tube size is way off the mark and apparently does NOT reflect the inside diameter. A 3/16" drill bit will barely fit inside 1/4" shrink label.
|
Very true. I was concerned the 1/2” I used would not shrink well on the wire I used. It fit like a glove. I think the dymo measurement is from side to side (OD diameter) vs inside diameter of the heat shrink (ID most are used to).
I used 14awg and some 12awg on the bigger stuff. You can see from pics how it turned out. You may want to leave a space to put the shoulder of your heat shrinks so you don’t have a mishap like I did on the blower label. The R in blower is bigger because I didn’t leave room at bottom for shoulder… oh well I’m only one who knows or cares I suppose. But I’m still tempted to redo it.
11-04-2022, 05:25 PM
Threaded Mode