Classic SeaCraft Community  

Go Back   Classic SeaCraft Community > Recovered Threads

Notices

Reply
 
Thread Tools Search this Thread Display Modes
  #11  
Old 08-26-2014, 11:03 AM
shine shine is offline
Moderator
 
Join Date: Sep 2010
Location: Vero Beach, FL
Posts: 597
Default

Quote:
Originally Posted by dave s View Post
Joel, I can see in that pic your almost at the windon; how do you like that rod fighting the swordfish?

Also that rod showed the bite fairly well.
Hi Dave, Yeah I think that picture was after the weight came off and the fish went back down. I really like that length of white 130 at the tip. I like the rod too, it loads up nice, and the bite is clear. The manual crank quit working a few trips ago, have to take it apart and figure out how to fix it.


Quote:
Is that a Dolphin electric?
It is. I got it from DaveS !
Reply With Quote
  #12  
Old 08-26-2014, 11:17 AM
dave s dave s is offline
Recovered
 
Join Date: Feb 2014
Posts: 137
Default

Is the handle not engaging or is it turning with the motor?
There are four Allen head screws in that ss sleeve next to the handle; loosen them and the handle will come off. There is a pin in the end that engages the the low gear; pull it out and make sure it's clean and no salt on it.
Hope this helps, but it's a fairly simple system.
You can always call Zsolt at Dolphin reels in Bradenton, FL.
Reply With Quote
  #13  
Old 08-27-2014, 09:34 AM
shine shine is offline
Moderator
 
Join Date: Sep 2010
Location: Vero Beach, FL
Posts: 597
Default

Quote:
Originally Posted by dave s View Post
Is the handle not engaging or is it turning with the motor?
There are four Allen head screws in that ss sleeve next to the handle; loosen them and the handle will come off. There is a pin in the end that engages the the low gear; pull it out and make sure it's clean and no salt on it.
Hope this helps, but it's a fairly simple system.
You can always call Zsolt at Dolphin reels in Bradenton, FL.
"fixed" it, the little allen screws were just loose
Reply With Quote
  #14  
Old 08-27-2014, 10:45 PM
dave s dave s is offline
Recovered
 
Join Date: Feb 2014
Posts: 137
Talking

Don't tighten the Allen screws too much, otherwise the handle will spin when you engage the electric drive.
Also the screws sit between the two channels on the drive shaft so the handle doesn't fall off.

You have to find the screws happy spot!
Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 05:38 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
All original content © 2003-2013 ClassicSeacraft