Classic SeaCraft Community  

Go Back   Classic SeaCraft Community > Recovered Threads

Notices

Reply
 
Thread Tools Search this Thread Display Modes
  #51  
Old 02-17-2017, 10:44 PM
77SceptreOB 77SceptreOB is offline
Senior Member
 
Join Date: Jun 2009
Location: Columbia, SC.
Posts: 1,611
Default

Do you have any expansion joints in that pour?
__________________
1977 SeaCraft 23' Sceptre W/ Alum Tower & Yamaha 225
www.LouveredProductsUnlimited.com
Reply With Quote
  #52  
Old 02-17-2017, 10:56 PM
Copper Collar Copper Collar is offline
Member
 
Join Date: Jul 2013
Location: Moyock, NC
Posts: 77
Default

Yes, 3 joints. It's 60ft long till the 45* out by the front side walk and 14ft off the wall with the meter on it. Just under 1100 sq/ft.
Reply With Quote
  #53  
Old 02-26-2017, 02:44 PM
Copper Collar Copper Collar is offline
Member
 
Join Date: Jul 2013
Location: Moyock, NC
Posts: 77
Default

Reply With Quote
  #54  
Old 02-26-2017, 09:10 PM
kmoose kmoose is offline
Senior Member
 
Join Date: Jul 2006
Location: Ocala, Florida
Posts: 1,817
Default

I hope you had the power company run your underground service feeding your meter in conduit. If they have a fault in the cable their only option will be to jackhammer it up. Same thing with the buried phone drop.
__________________
[b]The Moose is Loose !
Reply With Quote
  #55  
Old 02-27-2017, 09:27 PM
Copper Collar Copper Collar is offline
Member
 
Join Date: Jul 2013
Location: Moyock, NC
Posts: 77
Default

Quote:
Originally Posted by kmoose View Post
I hope you had the power company run your underground service feeding your meter in conduit. If they have a fault in the cable their only option will be to jackhammer it up. Same thing with the buried phone drop.
Didn't worry about the underground feed. Odds of that happening are slim to none. Then again this is the internet so I am sure hours after posting, I will be hit with a zombie apocalypse and a velociraptor attack which will end just in time for the sharknado. Then everyone will point out "told you so".

PVC was ran under the slab incase the phone line needs to be replaced.
Reply With Quote
  #56  
Old 02-28-2017, 07:43 AM
uncleboo uncleboo is offline
Senior Member
 
Join Date: Sep 2009
Location: Edenton, NC
Posts: 1,583
Default

And I must say the color of the boat blends with the house quite nicely!
__________________
1975 SF18/ 2002 DF140
1972 15' MonArk/ 1972 Merc 50
http://i833.photobucket.com/albums/z...photos/SC3.jpg
Reply With Quote
  #57  
Old 02-28-2017, 08:38 AM
kmoose kmoose is offline
Senior Member
 
Join Date: Jul 2006
Location: Ocala, Florida
Posts: 1,817
Default

Quote:
Originally Posted by Copper Collar View Post
Didn't worry about the underground feed. Odds of that happening are slim to none. Then again this is the internet so I am sure hours after posting, I will be hit with a zombie apocalypse and a velociraptor attack which will end just in time for the sharknado. Then everyone will point out "told you so".

PVC was ran under the slab incase the phone line needs to be replaced.
I'm a little jaded in the faulted secondary cable scenario due to the fact I was a lineman for 20 years and fixed thousands of ug faults where there was a lot of digging was involved. While it wasn't always the case, it seemed Murphy's law did like to land on faults where customers placed driveways and slabs over the cable. It could of been just my bad luck as I was the one who fixed them.

The risk of a faulted cable is most likely at the splice point if a temp meter pedestal was installed right next to the house during construction. If that was the case a splice was made from the temp meter location to where a second cable piece entered the house, usually 6' from the permanents meter location. If they had the temp service located near the road you are likely good as there would be no splice. If there was a problem they could cut an area of the slab out around the meter pipe and jet a 2" inch pipe under the slab and replace the cable that way.
__________________
[b]The Moose is Loose !
Reply With Quote
  #58  
Old 02-26-2020, 11:29 AM
Surfnski Surfnski is offline
Member
 
Join Date: Jul 2009
Location: Virginia Beach, VA
Posts: 91
Default

Good to hear. Looking forward to seeing some updated pics.
Reply With Quote
  #59  
Old 06-27-2020, 08:48 PM
Copper Collar Copper Collar is offline
Member
 
Join Date: Jul 2013
Location: Moyock, NC
Posts: 77
Default




Just need to finish wiring, fuel lines, rigging, and steering hydro lines/cylinder.


Oh and props
Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 11:39 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
All original content © 2003-2013 ClassicSeacraft