|
|
#1
06-16-2009, 01:31 AM
|
|||
|
|||
Morse control problems
I have a single morse control to operate my o/b yam. 250. I have no problem with foward shifting/throttle power. The motor shifts into reverse fine, but even with the throttle all of the way down in rev., I do not have any power. I guess its just not pulling enough cable to rev it up in reverse?? Any one have this set up, recommendations, is this typical w/this style control?? I guess the awnser would be to slow down while comming in, but I need to power to handle the boat next to oil platforms while fighting wind, current, waves. Thanks. Richard
|
|
#2
06-16-2009, 02:17 AM
|
|||
|
|||
|
Re: Morse control problems
should have some setscrews that lock in a detente - reverse may have loosened so its not engaging. Here's a couple of links.
http://www.nauticatusa.com/tips/cw_g...ftlinkage.aspx http://www.teleflexmarine.com/library/IS-NB.pdf http://www.ybw.com/forums/showflat.p...93/an/0/page/9
__________________
there's no such thing as normal anymore...
|
 |
|
|
Linear Mode
