Classic SeaCraft Community  

Go Back   Classic SeaCraft Community > General Discussion > Repairs/Mods.
FAQ Community Calendar Today's Posts Search

Notices

Reply
 
Thread Tools Search this Thread Display Modes
  #1  
Old 04-05-2012, 09:40 PM
jesusv jesusv is offline
Member
 
Join Date: Jun 2011
Location: south florida
Posts: 66
Default Inboard Transom

can anyone refer me to any possible 23 inboard transom rebuild threads i can use as a guideline. thanks J
Reply With Quote
  #2  
Old 04-05-2012, 10:02 PM
Wags23 Wags23 is offline
Member
 
Join Date: Feb 2009
Location: boston ma
Posts: 85
Default transom

heynow has a rebuild thread going
Reply With Quote
  #3  
Old 04-07-2012, 08:24 AM
heynow2203 heynow2203 is offline
Senior Member
 
Join Date: Dec 2010
Location: Dennis, MA
Posts: 394
Default

Do it from inside I used core cell with core bond
__________________
1976 Seacraft CC(Pilot House) Inboard Yanmar 315
1979 Septer I/O no power Sold
Reply With Quote
  #4  
Old 04-08-2012, 09:07 PM
jesusv jesusv is offline
Member
 
Join Date: Jun 2011
Location: south florida
Posts: 66
Default

I was planning on using ply. But I will look into corcell. What is the best way to remove the ply without damaging the outer skin. And if I wanted to record parts of the cap anyway should I just remove the entire cap or do it inplace and just remove the rear for transom repair? If I remove the entire thing will it oor the hull easily become warped?
Reply With Quote
  #5  
Old 04-10-2012, 06:27 PM
jesusv jesusv is offline
Member
 
Join Date: Jun 2011
Location: south florida
Posts: 66
Default transom

sorry for all the questions, a little hesitation kicks in when im about to start cutting into stuff. will i have to cut back the stringers when redoing the transom?
Reply With Quote
  #6  
Old 04-10-2012, 09:20 PM
heynow2203 heynow2203 is offline
Senior Member
 
Join Date: Dec 2010
Location: Dennis, MA
Posts: 394
Default

Yes you will have to cut back the stringers a bit to make good contact with transom also use 2x4's cut to lenght for. The hull so it doesn't get out of wack also make sure you have very good support under the hull. I would cut the cap I would pull it of whole and recore that at the same time it needs it
__________________
1976 Seacraft CC(Pilot House) Inboard Yanmar 315
1979 Septer I/O no power Sold
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 01:40 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
All original content © 2003-2013 ClassicSeacraft