|
|
#251
09-11-2016, 09:01 PM
|
|||
|
|||
Thru hull scuppers being installed
Well after some measuring and finding the correct hole saw bit I decided to drill some through hull scuppers drains for the deck.. in between the never ending fairing..
|
|
#252
09-11-2016, 09:39 PM
|
|||
|
|||
|
Scupper install
Quote:
|
|
#253
09-11-2016, 09:46 PM
|
|||
|
|||
|
1. Pic I measured and drilled the hole
2. Rabitt the hole out and then put a wet coat of epoxy on.. 3. Then back buttered the rest of the epoxy with cabosil thicken epoxy 4. I taped the thu hull up and waxed the snot out of her. 5. Installed it about 2/3 in let set up 6. Then pull out very carefully... 7. Inside the deck liner I modified the floor drains to mount vertically measured in from side 12" and drilled a hole . I am amazed at the thickness of glass on that liner.. about 1/2" thick
|
|
#258
10-22-2016, 10:09 PM
|
|||
|
|||
|
Started installing the trim tabs
Had some tabs laying around so I thought I better drill and in stall them... I want to have everything drilled and cut first then paint and reinstall the hardware..
|
|
#259
10-22-2016, 10:12 PM
|
|||
|
|||
|
First drilled holes oversize then chamfered the holes ,then I mixed a epoxy and brushed it in the holes ,then last I mixed some thickened and squirted it in the hole from the back to the front with them handy syringes
|
|
#260
11-27-2016, 09:19 PM
|
|||
|
|||
|
Still working on rub rail
About got the rubrqil done. I ordered the stainless 316L hollow back 3/4" from marine industries Inc.. great people and very friendly. Ordered3 -20' sticks... Very inexpensive with freight shipping...I should have the rubrqil done by the time it arrives...I started on the floor ,.. bought a 4*24 belt sander and commenced to know don the high spots and sand the whole deck down. To accommodate the teak...
|
 |
|
|
Linear Mode
