Classic SeaCraft Community  

Go Back   Classic SeaCraft Community > General Discussion > Repairs/Mods.
FAQ Community Calendar Today's Posts Search

Notices

Reply
 
Thread Tools Search this Thread Display Modes
  #1  
Old 06-20-2003, 05:43 PM
duckoff duckoff is offline
Junior Member
 
Join Date: Apr 2003
Location: North Carolina
Posts: 10
Default Master switch and isolator wiring

I am getting ready to add dual batteries to my 18cc. I planned to add a dual battery
master switch and an isolator. I am a little confused on the wiring process. Upon
looking at the diagrams that came with the switch and isolator and am unable to
figure out exactly how to wire them together correctly. I am wanting to use one battery for
starting and one for electronics and allow the motor to charge them together but
have the capability to utilize the deep cycle electronics battery for starting in a pinch.
I would like the motor to power everything while it is operating. Any help, suggestions, or
lewd comments would be appreciated!!! (well maybe not the lewd comments)
Reply With Quote
  #2  
Old 06-20-2003, 08:44 PM
hermco hermco is offline
Senior Member
 
Join Date: Mar 2002
Location: Jensen Beach, FL
Posts: 827
Default Re: Master switch and isolator wiring

Forget the isolator and wire the battery switch with one battery to terminal #1 and the other to terminal #2 the Common feed will power your motor etc. When you have the motor running switching the battery switch to the "All" position will allow the charging of both batteries by the motor allowing both to come up to full charge.Switching to the #1 position will allow the charging of the #1 battery alone etc.Be sure to keep the water level up in your batteries or you are f*****.
How is that for lewd!
Reply With Quote
  #3  
Old 06-21-2003, 09:20 AM
duckoff duckoff is offline
Junior Member
 
Join Date: Apr 2003
Location: North Carolina
Posts: 10
Default Re: Master switch and isolator wiring

Thanks, and thats pretty f*$#@%g lewd!!!
Reply With Quote
  #4  
Old 06-22-2003, 01:03 AM
Dave Hirshberg Dave Hirshberg is offline
Senior Member
 
Join Date: May 2003
Location: Fort Myers FL
Posts: 342
Default Re: Master switch and isolator wiring

Just as a side note, after installing the switch in the aforementined manner, don't get in the habit of starting the boat on one batt then switching the selector to a different position. Its really hard on most outboard motor electrical systems and can eventually fry the regulator rectifier in your motor. Instead start it on "all" and leave it there. If you stop and fish or anchor and swim, switch it to one or the other for running live wells and electronics so you have a spare fully charged batt to get the boat started again. But don't swith the batts while the engine is running.
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 10:26 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
All original content © 2003-2013 ClassicSeacraft