![]() |
#1
|
|||
|
|||
![]()
I found a 1987 bracketed, 225hp OX66 Yammy, t-top w/riggers, closed off transom, scuppers out the back.
Owner says the work was done by Wildfire Marine. Supposedly a well known Seacraft builder/modifier? Looks like a very clean job. Armstrong bracket. Scuppers go through the transom, from inside it looks like they go through the corners of the hull. Seems like a recessed area on each side that is lower than floor, where the scuppers go thru? Does that make sense? I will try to get a pic. I have been doing a lot of research on the 23. I understand this boat is not a Potter. Is there anything else to look for on a late 80's boat? Besides the obvious- soft deck, soft transom etc? I would like to be armed with as much info as possible. This boat is 1000 miles from me, and I will be flying down to inspect/test ride it. |
#2
|
|||
|
|||
![]() ![]() ![]() |
#3
|
|||
|
|||
![]()
Is the boat in Palm City FL? If so I have been to look at it.
|
#4
|
|||
|
|||
![]()
Hey Don,
Beautiful bracket!!! Thank you! OP |
#5
|
|||
|
|||
![]()
Glad you like it. Enjoy!
![]() |
#6
|
|||
|
|||
![]()
That is the one HermCo. I was pretty sure I wasnt the only one looking at it. Tough game to play from across the country!
Is that one of your brackets? Looks like an Armstrong? |
#7
|
|||
|
|||
![]()
I went and looked at it with a potential buyer. The bracket is an aluminum, probably an Armstrong since Wildfires shop is across the street from them.
![]() |
![]() |
|
|