Gas tank fluid removal

[Old'sCool]

Originally Posted by uncleboo

Or you could get a measurement through the filler inspection plate and cut a new one over the sender. I did this for a plate to access the pick up fitting when replacing the fuel lines. Used a mirror and a flashlight to see the fitting so I could see when the end of the tape was at the fitting.

I did the same on my 23' with clear lid to easily view the fill/vent area on the tank.

[cudabob]

Hi got old fuel out of the tank. Has anyone replaced this tank with a generic moeller tank? about 50 gallons.
old tank is 8" deep and 22 " wide