|
|
#1
05-16-2003, 03:25 PM
|
|||
|
|||
Re: trim around rod holder section of 20 ft seacraft
Rich; Sounds like you bought one? Congrats!
__________________
http://i212.photobucket.com/albums/c...9/IMG_0476.jpg 
|
|
#2
05-16-2003, 05:46 PM
|
|||
|
|||
|
Re: trim around rod holder section of 20 ft seacraft
There is a white plastic trim that has a aluminum insert that goes around the rod holder compartment.I bought a 100 foot rool for about $60 bucks.
The teak strip should have a aluminum track right on top of it and that is were the Bimini top mounts and slides.It is a pretty neet set up cause when the top is down it is out of the way and lays right in front of the engine. I can take a picture of mine if you would like to see it. Hammer
|
|
#3
05-17-2003, 01:55 AM
|
|||
|
|||
|
trim around rod holder section of 20 ft seacraft
was there any trim around the section where the rods goes on a 20 ft seacraft and i have a teak strip about 11/2x 3/4x 48 inches half way up about midship on the inside of boat any ideas what it was for also looks like something also went above it just below the gunnel edge have not seen this on pics of other boats thanks
|
|
#4
05-17-2003, 08:50 AM
|
|||
|
|||
|
Re: trim around rod holder section of 20 ft seacraft
hammer, whats the company that u purchased the trim from and a pic of the top and trim would be great..can be e-mailed to [email protected]ks
|
 |
|
|
Linear Mode
