|
|
#1
04-13-2010, 04:44 PM
|
|||
|
|||
Best way to seal bracket holes thru transom?
I just dry fit a new bracket and plan on taking it back off to seal/sleeve all of the mounting holes. What do you guys think is the best technique and/or material for doing this job?
Thanks!!! 
|
|
#2
04-13-2010, 08:43 PM
|
|||
|
|||
|
Re: Best way to seal bracket holes thru transom?
Where's Don when you need him
I believe 5200 for sealing holes and mounting bracket...again I believe..or was it 4200?! -Fred
__________________
"...Southern by the grace of God"
|
|
#3
04-13-2010, 09:02 PM
|
|||
|
|||
|
Re: Best way to seal bracket holes thru transom?
I believe this is the best method.
http://bertram31.com/proj/tips/sleeving.htm
__________________
73 23 SF 2004 200 HP Yami OX66 Best boat I owned! 2002 29 Seavee twin 200 yami's
|
|
#4
04-13-2010, 10:23 PM
|
|||
|
|||
|
Re: Best way to seal bracket holes thru transom?
- Oversize drill needed holes, fill with epoxy.
- Drill through center of the filled, cured epoxy hole w/ correct size bit for bolt(s). - Install/seal with polysulfide. - Don't look back. Good luck...
|
 |
|
|
Linear Mode
