forward bulkhead Cabin area -seacraft 23

geesea · #1 10-18-2010, 10:03 PM

need to make a new forward bulkhead for my seacraft 23.What would be the best material to use for this?

Islandtrader · #2 10-20-2010, 09:35 AM

A little more info. please.

Model of boat?
Interior or exterior bulk head?

NoBones · #3 10-21-2010, 03:22 PM

Must have been a hit and run.....

See ya, Ken

geesea · #4 10-22-2010, 03:59 PM

interior bulkhead. seacraft 23 savage. (inside cuddy area)thanks.

geesea · #5 10-22-2010, 04:00 PM

no bones- not everyone has all day to sit in front of their computer.

Islandtrader · #6 10-23-2010, 09:39 AM

This is sort of a open end answer.

If it was me(since I am in the middle of a big restore job) I would use what I have lying around etc. Marine ply or my plascore. Throw a layer of 1708 on each side, and fair out the side that shows.

So it would be up to you. I would think wood would do just fine, and is cost efficient and holds up if prepped right.

geesea · #7 10-23-2010, 07:43 PM

sounds like a plan. Thanks.