|
|
#1
03-24-2017, 09:13 AM
|
|||
|
|||
Gemlux Rodholder Wrench
Anyone got a Gemlux wrench I could borrow for some bluewater rodholders I'm going to install? I really want to go with the Gemlux design but would like to avoid buying the tool to install them if someone has one.
__________________
[b]The Moose is Loose ! 
|
|
#2
03-26-2017, 06:06 PM
|
|||
|
|||
|
I have them on my boat and i used a sink drain wrench. its adjustable and worked fine for me although I'm sure the socket is easier. I picked one up at harbor freight for a few dollars.
google this...at walmart Superior Tool 03840 Adjustable Combination Wrench Jim
|
|
#4
03-28-2017, 08:55 AM
|
|||
|
|||
|
I have a few temperature probes at my work that have 8" tubes on top of the nuts to tighten similar to this arrangement. I took a socket that fit the hex area and cut it in half. Then added a piece of pipe in-between the two. Kinda made a 12" deep, deep-well socket that would clear the tube that stuck out. Yours would take a large socket but napa will sell large single sockets. A large crows foot may work well too.
__________________
Current SeaCraft projects: 68 27' SeaCraft Race boat 71 20' SeaCraft CC sf 73 23' SeaCraft CC sf 74 20' SeaCraft Sceptre 74 20' SeaCraft CC sf
|
|
#5
03-28-2017, 02:20 PM
|
||||
|
||||
|
Quote:
__________________
   1978 23' Superfish/Potter Bracket 250HP -------- as "Americans" you have the right to ...... "LIFE, LIBERTY and the PURSUIT of a Classic SeaCraft" -capt_chuck
|
|
#6
03-28-2017, 04:05 PM
|
|||
|
|||
|
Well, you guys were a little late but I appreciate the enginuative ideas! I sprung for the socket but they will credit me the $75 back if I return it after my install.
__________________
[b]The Moose is Loose !
|
 |
|
|
Linear Mode
